Display asian characters (Japanese, Korean, Chinese,...) on Open file
Using the ANSI encoding; I can write Asian characters just fine and as long as I do not close the file I can close the program and next time at restart the characters will display correctly.
However if I close the file after saving, then try to open it again -either right after or after a software re/start- I will see “?” or square symbols instead.
How can I save the file so that after re-opening it the Asian characters will display correctly?
I assume that autodetect character encoding is enabled.
I would give it a try to check it with disabled auto-detection
uncheck autodetect character encoding